Description
German 50mm PaK 38 / KwK 39 Capped Armor-Piercing Round
This German 50mm Pzgr. 39 round combines a capped armor-piercing projectile with a 1943-dated steel case marked “6360 St” and “5cm Pak.” The projectile retains its nose cap, driving bands, and threaded base-fuze component. Surviving markings on the projectile, case, and primer give collectors several points of reference for studying German ammunition production during World War II. This round was used in both the PaK 38 anti-tank gun and the Panzer III's KwK 39 tank gun. A very rare round complete with base fuze! This is the only example that we have, so you will be receiving the exact round in the photos.
Capped Projectile and Base Fuze
The 5cm Pzgr. 39 was a capped armor-piercing projectile with a small bursting charge and a rear tracer. Its piercing cap helped the hardened steel body withstand impact against armor. This type used a Bd.Z. 5103-series base fuze with a delay intended to let the projectile penetrate before the bursting charge acted. The tracer helped crews observe the projectile’s flight.
Steel Case and Percussion Primer
The “6360 St” marking means the steel case was used for PaK ammunition, while “5cm Pak” states its antitank-gun application. The installed C/12 nA is a percussion primer, the ignition system used by the towed PaK 38. The long-barreled 5cm KwK 39 tank-gun family also used the 6360 case family, but its ammunition used C/22 electric primers.
PaK 38 Development and Wartime Service
Rheinmetall-Borsig developed the 5cm PaK 38 L/60 as a more powerful successor to Germany’s 3.7cm antitank gun. Development began in 1938, and the gun started replacing the smaller weapon in late 1940 as heavier tank armor demanded better performance. Its long barrel, muzzle brake, and semiautomatic horizontal sliding-block breech combined increased power with a practical firing rate of about 10–15 rounds per minute. A split-trail carriage, torsion-bar suspension, and double shield supported its role as a mobile, motor-towed gun for German antitank units. The type served with the Afrika Korps in North Africa, where Australian forces encountered it during 1941–42. The more powerful 7.5cm PaK 40 later took over much of its frontline role as tank protection increased, although it never completely replaced the PaK 38 during the war.
Condition
The pictured round shows dark finish remnants, mottled surface corrosion, scratches, and pitting on the projectile and case. The exposed base-fuze body has heavier corrosion and wear. The primer body remains installed in the case. All ordnance is inert. Please check the pictures for the general condition of the item.
Ideal For
The separate component markings and visible projectile construction make this round useful for focused collections and educational displays.
- German World War II antitank ammunition collections.
- PaK 38 museum exhibits and static restoration displays.
- Research into wartime case, primer, and projectile markings.
Approx length 22.5", Approx width 3", Approx height 3", Approx weight 7lbs.
Pictures are stock images of our inventory. Unless otherwise noted, you will not be receiving the exact item shown in the pictures. The pictures are representative of the item’s general condition. The item you receive might be slightly better, or worse, condition than was shown in the pictures.
Please visit our page about order lead times here: Order Lead Times.